Nitex Enterprises, India
Simatherm Induction Heaters
Products | Simatec | Simatherm

Simatherm Induction Heater IH 210

Simatherm

Simatherm Induction Heater IH 210The IH 210 is intended to heat large work pieces up to 300 kg. The IH 210 comes equipped with two yokes. Due to the sliding yoke, one can mount and remove the work piece.

An additional benefit of IH 210 is its built in air-cooling system (IH 210F), which allows continuous operation or even a higher platform, for larger work pieces (IH 210XL).

Technical Data

Criteria Designation
Designations IH 210/400V, 50 Hz - 460V/60 Hz
IH 210/500V, 50 Hz - 575V/60 Hz
Workpiece
- Maximum weight
- Bore diameter

300 kg 60-600 mm
Temperature control
- Range
- Magnetic probe
- Accuracy (electronics)

0-250 C yes, type K +/-3 C
Time control
- Range
- Accuracy

0-60 minutes
+/-0.01 seconds
Maximum temperature 400 C
Thermometer mode Yes
Bearing temperature mode Yes
Power reduction 4-step /
20-40-60-80 %
Automatic demagnetisation residual magnetism Yes
< 2A/cm
Can heat sealed bearings Yes
Can heat pre-greased bearings yes
Error guiding codes Yes
Thermal overload protection Yes
Maximum magnetic flux 1,5 T
Control panel Keyboard with LED-display
Size of the operating area (W x H)
250 x 250 mm
Coil diameter 135 mm
Dimensions (W x D x H) 600 x 350 x 420 mm
Overall weight including yokes 75 kg
Maximum power consumption 10 / 11.5 kVA
Standard yokes 40 x 40 x 420 mm
70 x 70 x 420 mm
Core cross section 70 x 70 mm
Yoke storage Yes, internal
Sliding arm Yes
Swivel arm -
Cooling fan Optional
Housing material Aluminium